Turbine Flow Meter – Axial Turbine Meter (Sanitrary)
Category: Turbine Flowmeter
Specifications
Sizes
" - 8" (4-200 mm)
Temperature
-4-300°F ( -20 ~ +150℃)
Accuracy
0.5%
Viscosity
1 to 10 cSt
Operating Pressure
up to 150 psi (10 bar)
Material
SS #316L (body) 2Cr13 or CD4MCu (rotors) Tungsten Carbide (Bearings)
Signal Output
4-20mA, pulse, Modbus, HART
Process Connection
Sanitary Flanges
Process Medium
Clean liquids
Application
Food and beverage
Details
ALTM turbine flow meters (hereinafter referred to as turbines) are used for the precise measurement of instantaneous flow rates of low- viscosity fluids as tap and demineralized water, fuels, liquefied gases, light fuel oils, solvents, and pharmaceutical fluids. Turbine flowmeters measure volumetric flow, where fluid passing through the meter body is measured by the mean velocity of the flowing fluid media. Flow rectifiers ensure a laminar flow in the axial direction of the wheel. A low-mass turbine wheel carried concentrically within the meter body is rotated by the fluid. The RPM of the turbine wheel is directly proportional to the mean flow rate within the meter body and directly corresponds to the volumetric flow over a wide range.
- Sanitary Turbine Meters
- " - 8" (4-200 mm)
- -4-300°F ( -20 ~ +150℃)
- 0.5%
- 1 to 10 cSt
- up to 150 psi (10 bar)
- SS #316L (body) 2Cr13 or CD4MCu (rotors) Tungsten Carbide (Bearings)
- 4-20mA, pulse, Modbus, HART
- Sanitary Flanges
- Clean liquids
- Food and beverage
View more about Turbine Flow Meter – Axial Turbine Meter (Sanitrary) on main site